iNet Network Scanner 4.0.4 Mac

Port scan settings, reachable right from the ports list header, are the kind of small, sharp change that tells you who iNet Network Scanner is built for. The 4.0.4 update from BananaGlue doesn’t add flash; it cuts a step out of a workflow that a sysadmin or network engineer repeats dozens of times a day.

Tools beyond the device list

Most network scanners stop at showing you a table of IP addresses and vendor names. iNet goes further with a toolkit that rewards digging:

• A port scanner that, as of version 4.0.4, runs noticeably faster and surfaces its configuration directly from the results header.
• A Bonjour browser that enumerates every advertised service per device — not just a count, but the actual services.
• Wake on LAN and Sleep on LAN for remote power control, paired with detailed device info that identifies specific Apple computer models.

Reading a network like a beat reporter

The app detects and distinguishes Windows and Macintosh machines, pulls manufacturer names, providers, and IP addresses, and now taps into MAC-address data on newer Apple mobile operating systems for better identification. Apple Silicon and Intel Macs running macOS 12.4 or later are both supported. An extensive help section sits behind it all, written for people who want to understand a scan, not just see it.

Bonjour browser flags a vanished printer before the first coffee

IT support staff in small to mid-sized offices tend to lean on it hardest. When a printer stops advertising itself on the network at 8:45 a.m., the Bonjour browser shows in seconds whether the service disappeared or the whole device dropped. Home users with a closet full of smart-home gear — cameras, bridges, a stray Raspberry Pi running HomeBridge — use the scan as a quick inventory, especially after a router swap or a firmware update that reassigns half the IPs in the house.

Mac-heavy households also benefit from the model-level identification. Knowing exactly which Mac mini in the den is still awake and responding to ping saves the walk downstairs. People who grab the inet network scanner mac full version often fit a profile: they want the port scanner and the Wake-on-LAN tools without splitting the job across three different utilities.

Mistakes that slow a scan down

New users sometimes open the port scanner and sweep the entire 1–65535 range against a single device with no rate limiting, then wonder why the result feels sluggish. The tool can handle it, but a targeted scan of the first 1024 ports answers most real questions — what services are actually listening — without the wait.

Another common slip is ignoring the device-type filters in the main view. A flat list of every iPhone, smart speaker, and thermostat on a /24 subnet reads like noise. Filtering to show only computers or only Bonjour-advertising hosts turns the same data into a map of what matters. Beginners also miss that Sleep on LAN works only for Macs; sending it to a Windows box does nothing, and the lack of feedback can make it look like the feature is broken when it simply found no compatible target.

Version 4.0.4 improves manufacturer detection with access to MAC addresses in iOS 27. Port scanning is faster, and the ports list header now provides quick access to scan settings.

• macOS 12.4 or later
• Apple Silicon or Intel 64-bit